Hello MathWorks community,

I’m currently working on my Speedgoat RealTime target, and I would like to perform Data Replay, using the block Signal Editor.
My scenario is well configured, and the simulation works pretty well, but currently the data are generated by the Signal Editor as soon the simulation Start. However I need before to wake-up the DUT and let him correctly initialize …
We can imagine to use a Switch bloc with 2 differents bus with the data comming from the Signal Editor, and from the plant model to allow the DUT to correctly init. Unfortunalty, because the Signal Editor is already sending the data, I cannot perform the replay testing as expected.

Is there an option for controlling the Signal Editor (such as start/stop/loop) with Simulink RealTime during the Simulation ?

Thank you for your advice !
RegardsHello MathWorks community,

I’m currently working on my Speedgoat RealTime target, and I would like to perform Data Replay, using the block Signal Editor.
My scenario is well configured, and the simulation works pretty well, but currently the data are generated by the Signal Editor as soon the simulation Start. However I need before to wake-up the DUT and let him correctly initialize …
We can imagine to use a Switch bloc with 2 differents bus with the data comming from the Signal Editor, and from the plant model to allow the DUT to correctly init. Unfortunalty, because the Signal Editor is already sending the data, I cannot perform the replay testing as expected.

Is there an option for controlling the Signal Editor (such as start/stop/loop) with Simulink RealTime during the Simulation ?

Thank you for your advice !
Regards Hello MathWorks community,

I’m currently working on my Speedgoat RealTime target, and I would like to perform Data Replay, using the block Signal Editor.
My scenario is well configured, and the simulation works pretty well, but currently the data are generated by the Signal Editor as soon the simulation Start. However I need before to wake-up the DUT and let him correctly initialize …
We can imagine to use a Switch bloc with 2 differents bus with the data comming from the Signal Editor, and from the plant model to allow the DUT to correctly init. Unfortunalty, because the Signal Editor is already sending the data, I cannot perform the replay testing as expected.

Is there an option for controlling the Signal Editor (such as start/stop/loop) with Simulink RealTime during the Simulation ?

Thank you for your advice !
Regards signal editor, simulink realtime, speedgoat MATLAB Answers — New Questions

​