Hi,
I am experimenting within Simulink, and I wish to be able to run a simulation while clocking in input data several times during the simulation. I though to use a selector block and a counter limited block, however I keep getting run-time errors which identify a range problem with the idx input on the selector. I have set the Starting index (port) option in the selector and also set the input port size to 1, but the error says it is not in the permissable range (0 through 0).
I’m a bit confused with the error, and I am hoping it could be further explained. Further guidance would be appreciated.
I have attached a capture of my test with the parameters and the error for context.
Regards.Hi,
I am experimenting within Simulink, and I wish to be able to run a simulation while clocking in input data several times during the simulation. I though to use a selector block and a counter limited block, however I keep getting run-time errors which identify a range problem with the idx input on the selector. I have set the Starting index (port) option in the selector and also set the input port size to 1, but the error says it is not in the permissable range (0 through 0).
I’m a bit confused with the error, and I am hoping it could be further explained. Further guidance would be appreciated.
I have attached a capture of my test with the parameters and the error for context.
Regards. Hi,
I am experimenting within Simulink, and I wish to be able to run a simulation while clocking in input data several times during the simulation. I though to use a selector block and a counter limited block, however I keep getting run-time errors which identify a range problem with the idx input on the selector. I have set the Starting index (port) option in the selector and also set the input port size to 1, but the error says it is not in the permissable range (0 through 0).
I’m a bit confused with the error, and I am hoping it could be further explained. Further guidance would be appreciated.
I have attached a capture of my test with the parameters and the error for context.
Regards. selector block, counter limited, reset counter MATLAB Answers — New Questions

​