I have a simulation on MATLAB Simulink. I run the simulation and I can view the results on scopes. I can save the results from scopes as MATLAB figures, etc. I can also save the workspace (full or partial).

What I want to do is that when I close the simulation, and open it again, it should be at the point where I closed it. In other words, I want to run a simulation and save it in such a way whenever I need it, I just need to open that file without the need to run it again. In this way, I do not have to save all the results of the scopes one by one. This will speed up my work. It will also help me to save my hard disk space. Moreover, I will not have to spend time to decide which result is important and which is not. I can just open a pre-run simulation and view my required results.I have a simulation on MATLAB Simulink. I run the simulation and I can view the results on scopes. I can save the results from scopes as MATLAB figures, etc. I can also save the workspace (full or partial).

What I want to do is that when I close the simulation, and open it again, it should be at the point where I closed it. In other words, I want to run a simulation and save it in such a way whenever I need it, I just need to open that file without the need to run it again. In this way, I do not have to save all the results of the scopes one by one. This will speed up my work. It will also help me to save my hard disk space. Moreover, I will not have to spend time to decide which result is important and which is not. I can just open a pre-run simulation and view my required results. I have a simulation on MATLAB Simulink. I run the simulation and I can view the results on scopes. I can save the results from scopes as MATLAB figures, etc. I can also save the workspace (full or partial).

What I want to do is that when I close the simulation, and open it again, it should be at the point where I closed it. In other words, I want to run a simulation and save it in such a way whenever I need it, I just need to open that file without the need to run it again. In this way, I do not have to save all the results of the scopes one by one. This will speed up my work. It will also help me to save my hard disk space. Moreover, I will not have to spend time to decide which result is important and which is not. I can just open a pre-run simulation and view my required results. saving a simulation MATLAB Answers — New Questions

​