Hi,
I am using an F28388D to control a 3-phase full bridge inverter. I am utilizing a code with a state diagram for this purpose. I have a requirement to completely turn off the third leg of the inverter at one point for a few seconds based on inputs from Stateflow. I tried using the software force logic, but I am unable to turn off the switches. The attached diagram shows the settings I have tried for this. I provided an input of 1 to the SW input port whenever I needed to turn off the leg, but it’s not working, and I am unable to find any resources on how to implement this.
Is there anyone who can help with this?
Thanks in advance.
Regards,
KripaHi,
I am using an F28388D to control a 3-phase full bridge inverter. I am utilizing a code with a state diagram for this purpose. I have a requirement to completely turn off the third leg of the inverter at one point for a few seconds based on inputs from Stateflow. I tried using the software force logic, but I am unable to turn off the switches. The attached diagram shows the settings I have tried for this. I provided an input of 1 to the SW input port whenever I needed to turn off the leg, but it’s not working, and I am unable to find any resources on how to implement this.
Is there anyone who can help with this?
Thanks in advance.
Regards,
Kripa Hi,
I am using an F28388D to control a 3-phase full bridge inverter. I am utilizing a code with a state diagram for this purpose. I have a requirement to completely turn off the third leg of the inverter at one point for a few seconds based on inputs from Stateflow. I tried using the software force logic, but I am unable to turn off the switches. The attached diagram shows the settings I have tried for this. I provided an input of 1 to the SW input port whenever I needed to turn off the leg, but it’s not working, and I am unable to find any resources on how to implement this.
Is there anyone who can help with this?
Thanks in advance.
Regards,
Kripa c2000, f28388d, epwm MATLAB Answers — New Questions

​