I’m comparing the output of the IdIq map with the input of RPM and torque and IdIq in the experimental data. I calculated IdIq with the equation as shown in the capture picture in the 3 phase current, which is the dynamo experimental data. But the value level doesn’t match the map value. The value in the map is id -280,iq 89. The result of calculation is id 0,iq300. Is there something wrong with the equation below? I’ve selected all the D-axis and Q-axis in the ParkTransform library, but id iq only change the value.I’m comparing the output of the IdIq map with the input of RPM and torque and IdIq in the experimental data. I calculated IdIq with the equation as shown in the capture picture in the 3 phase current, which is the dynamo experimental data. But the value level doesn’t match the map value. The value in the map is id -280,iq 89. The result of calculation is id 0,iq300. Is there something wrong with the equation below? I’ve selected all the D-axis and Q-axis in the ParkTransform library, but id iq only change the value. I’m comparing the output of the IdIq map with the input of RPM and torque and IdIq in the experimental data. I calculated IdIq with the equation as shown in the capture picture in the 3 phase current, which is the dynamo experimental data. But the value level doesn’t match the map value. The value in the map is id -280,iq 89. The result of calculation is id 0,iq300. Is there something wrong with the equation below? I’ve selected all the D-axis and Q-axis in the ParkTransform library, but id iq only change the value. idiq calculation MATLAB Answers — New Questions

​