I use the new battery simscape blocks for a battery simulation. Now I want to limit the SOC from 1 to 0. Actually I want to limit the single cell voltage (4.2V to 2.5V). Is this possible via the parameter table or do you have any other suggestions?

The saturator block in the Figure is actually only used to embellish my graphics and not to limit the voltage.
That only a maximum of 4.2 volts are available with a SOC of 1.
Properties: CellV = 4.2 V 24s5p with 8 Module in the packI use the new battery simscape blocks for a battery simulation. Now I want to limit the SOC from 1 to 0. Actually I want to limit the single cell voltage (4.2V to 2.5V). Is this possible via the parameter table or do you have any other suggestions?

The saturator block in the Figure is actually only used to embellish my graphics and not to limit the voltage.
That only a maximum of 4.2 volts are available with a SOC of 1.
Properties: CellV = 4.2 V 24s5p with 8 Module in the pack I use the new battery simscape blocks for a battery simulation. Now I want to limit the SOC from 1 to 0. Actually I want to limit the single cell voltage (4.2V to 2.5V). Is this possible via the parameter table or do you have any other suggestions?

The saturator block in the Figure is actually only used to embellish my graphics and not to limit the voltage.
That only a maximum of 4.2 volts are available with a SOC of 1.
Properties: CellV = 4.2 V 24s5p with 8 Module in the pack batterybuilder, pack, simscape battery, batterymodel, buildbattery MATLAB Answers — New Questions

​