[Simscape] Having two thermal liquid loops with different thermal liquid settings?
I’m modeling a two-loop system on both sides of a heat exchanger and clearly each loop uses different heat transfer fluid.
So I though I should be able to connect two different thermal liquid setting blocks on each side of the heat exchanger, but I’m getting the following error.
"Failed to propagate domain parameters. Domain parameters are propagated to the same set of nodes from sources: ‘Thermal_Liquid_Settings_TL.A’ and ‘SecondaryLoop.Thermal_Liquid_Settings_TL2.A’. Each node may only have at most one source of propagation."
Doesn’t this feel like a bug in the current heat exchanger model? Surely the properties could be different. The version I’m on is 2021b. I’ll try to look for ways to bypass it (maybe first go to a newer version), but if anyone happens to know about this issue, please share your ideas.I’m modeling a two-loop system on both sides of a heat exchanger and clearly each loop uses different heat transfer fluid.
So I though I should be able to connect two different thermal liquid setting blocks on each side of the heat exchanger, but I’m getting the following error.
"Failed to propagate domain parameters. Domain parameters are propagated to the same set of nodes from sources: ‘Thermal_Liquid_Settings_TL.A’ and ‘SecondaryLoop.Thermal_Liquid_Settings_TL2.A’. Each node may only have at most one source of propagation."
Doesn’t this feel like a bug in the current heat exchanger model? Surely the properties could be different. The version I’m on is 2021b. I’ll try to look for ways to bypass it (maybe first go to a newer version), but if anyone happens to know about this issue, please share your ideas. I’m modeling a two-loop system on both sides of a heat exchanger and clearly each loop uses different heat transfer fluid.
So I though I should be able to connect two different thermal liquid setting blocks on each side of the heat exchanger, but I’m getting the following error.
"Failed to propagate domain parameters. Domain parameters are propagated to the same set of nodes from sources: ‘Thermal_Liquid_Settings_TL.A’ and ‘SecondaryLoop.Thermal_Liquid_Settings_TL2.A’. Each node may only have at most one source of propagation."
Doesn’t this feel like a bug in the current heat exchanger model? Surely the properties could be different. The version I’m on is 2021b. I’ll try to look for ways to bypass it (maybe first go to a newer version), but if anyone happens to know about this issue, please share your ideas. simscape MATLAB Answers — New Questions