I am aiming to create a Hybrid electric vehicle architecture with four wheel drive to simulate wide-open-throttle. I also aim to introduce a DCT.
I cannot get the Generic Engine to work individually – it will run at the initial ‘idle’ rpm and then fail.
I cannot work out why it produces no torque to my gearbox at all, I have used many ‘Generic Engine’ Models as references too.
Sometimes, it fails fast due to the maximum engine speed being reached, without any torque being produced or any drive happening. Almost as if a car is in neautral, for example.
There are no error codes attached.I am aiming to create a Hybrid electric vehicle architecture with four wheel drive to simulate wide-open-throttle. I also aim to introduce a DCT.
I cannot get the Generic Engine to work individually – it will run at the initial ‘idle’ rpm and then fail.
I cannot work out why it produces no torque to my gearbox at all, I have used many ‘Generic Engine’ Models as references too.
Sometimes, it fails fast due to the maximum engine speed being reached, without any torque being produced or any drive happening. Almost as if a car is in neautral, for example.
There are no error codes attached. I am aiming to create a Hybrid electric vehicle architecture with four wheel drive to simulate wide-open-throttle. I also aim to introduce a DCT.
I cannot get the Generic Engine to work individually – it will run at the initial ‘idle’ rpm and then fail.
I cannot work out why it produces no torque to my gearbox at all, I have used many ‘Generic Engine’ Models as references too.
Sometimes, it fails fast due to the maximum engine speed being reached, without any torque being produced or any drive happening. Almost as if a car is in neautral, for example.
There are no error codes attached. generic engine, vehicle model, ice engine, torque issue, engine issue MATLAB Answers — New Questions