I’m using Nucleo-G474RE to send a bit stream over Simulink, instead of receiving 24 bits on the oscilloscope i can read only 8 bits, which are supposed to be the 8 bits in the middle that have the address of the peripheral and the status of the I2C block gives me 516 which is not on the documentation from matlab.I’m using Nucleo-G474RE to send a bit stream over Simulink, instead of receiving 24 bits on the oscilloscope i can read only 8 bits, which are supposed to be the 8 bits in the middle that have the address of the peripheral and the status of the I2C block gives me 516 which is not on the documentation from matlab. I’m using Nucleo-G474RE to send a bit stream over Simulink, instead of receiving 24 bits on the oscilloscope i can read only 8 bits, which are supposed to be the 8 bits in the middle that have the address of the peripheral and the status of the I2C block gives me 516 which is not on the documentation from matlab. i2c, nucleo-g474re MATLAB Answers — New Questions

​