Hello,
For one of my university project we are tasked with designing a suspension system. Using hand calculations I have worked out that the maximum displacement of the mass should be 19.5mm when the spring stiffness is 54772.5N/m and the damping ratio is 3462.78N/(m/s). However, when I am modelling this system on simscape I get a displacement of around 200mm. I am new to using this software so suggestions as to where I’m going wrong would be great.
Below is the setup I’m trying to model where v=13.33m/s , go=0.015m and d=5m

This is the setup I’ve been using on simscapeHello,
For one of my university project we are tasked with designing a suspension system. Using hand calculations I have worked out that the maximum displacement of the mass should be 19.5mm when the spring stiffness is 54772.5N/m and the damping ratio is 3462.78N/(m/s). However, when I am modelling this system on simscape I get a displacement of around 200mm. I am new to using this software so suggestions as to where I’m going wrong would be great.
Below is the setup I’m trying to model where v=13.33m/s , go=0.015m and d=5m

This is the setup I’ve been using on simscape Hello,
For one of my university project we are tasked with designing a suspension system. Using hand calculations I have worked out that the maximum displacement of the mass should be 19.5mm when the spring stiffness is 54772.5N/m and the damping ratio is 3462.78N/(m/s). However, when I am modelling this system on simscape I get a displacement of around 200mm. I am new to using this software so suggestions as to where I’m going wrong would be great.
Below is the setup I’m trying to model where v=13.33m/s , go=0.015m and d=5m

This is the setup I’ve been using on simscape suspension, displacement, simscape, mass, damper, spring MATLAB Answers — New Questions

​