I am working on an AUTOSAR architecture using Simulink.
I can compile it without problems, but whenever I perform an action: adding a constant to the dictionary, changing the dimension of a data type or even executing the command
archDict = Simulink.dictionary.archdata.open(‘BmsDataDictionary.sldd’)
I get the error:
The call to autosar_make_rtw_hook, during the after_tlc hook generated the following error:
Expected application type to be mapped

The build process will terminate as a result.
Caused by:
Expected application type to be mapped
I have modified the dictionary in the past, I can’t figure out what is happeningI am working on an AUTOSAR architecture using Simulink.
I can compile it without problems, but whenever I perform an action: adding a constant to the dictionary, changing the dimension of a data type or even executing the command
archDict = Simulink.dictionary.archdata.open(‘BmsDataDictionary.sldd’)
I get the error:
The call to autosar_make_rtw_hook, during the after_tlc hook generated the following error:
Expected application type to be mapped

The build process will terminate as a result.
Caused by:
Expected application type to be mapped
I have modified the dictionary in the past, I can’t figure out what is happening I am working on an AUTOSAR architecture using Simulink.
I can compile it without problems, but whenever I perform an action: adding a constant to the dictionary, changing the dimension of a data type or even executing the command
archDict = Simulink.dictionary.archdata.open(‘BmsDataDictionary.sldd’)
I get the error:
The call to autosar_make_rtw_hook, during the after_tlc hook generated the following error:
Expected application type to be mapped

The build process will terminate as a result.
Caused by:
Expected application type to be mapped
I have modified the dictionary in the past, I can’t figure out what is happening autosar, autosar blockset, simulink, software architecture, composition, dictionary MATLAB Answers — New Questions

​