Hello everyone,

I am simulating a CT volume that includes a couple of different structures using the "createSyntheticSkullCT" function. After that, I generate X-ray projections from the CT volume.

My goal is to move this CT volume in 6D, which includes translation in millimeters (X, Y, Z) and rotation in degrees (roll, pitch, yaw). To achieve this, I defined a function called "applyRigidTransform3D" in code 1 and "rigidTransform6D" in code 2 for the 6D movements, but I am not sure if this function is working correctly.

I would greatly appreciate any insights or suggestions regarding this code. Is my simulation realistic? If not, which parts contain errors? I would also welcome any recommended validation or sanity checks.

I have attached the MATLAB codes (Code1.m and Code2.m) below for reference.

Thank you!Hello everyone,

I am simulating a CT volume that includes a couple of different structures using the "createSyntheticSkullCT" function. After that, I generate X-ray projections from the CT volume.

My goal is to move this CT volume in 6D, which includes translation in millimeters (X, Y, Z) and rotation in degrees (roll, pitch, yaw). To achieve this, I defined a function called "applyRigidTransform3D" in code 1 and "rigidTransform6D" in code 2 for the 6D movements, but I am not sure if this function is working correctly.

I would greatly appreciate any insights or suggestions regarding this code. Is my simulation realistic? If not, which parts contain errors? I would also welcome any recommended validation or sanity checks.

I have attached the MATLAB codes (Code1.m and Code2.m) below for reference.

Thank you! Hello everyone,

I am simulating a CT volume that includes a couple of different structures using the "createSyntheticSkullCT" function. After that, I generate X-ray projections from the CT volume.

My goal is to move this CT volume in 6D, which includes translation in millimeters (X, Y, Z) and rotation in degrees (roll, pitch, yaw). To achieve this, I defined a function called "applyRigidTransform3D" in code 1 and "rigidTransform6D" in code 2 for the 6D movements, but I am not sure if this function is working correctly.

I would greatly appreciate any insights or suggestions regarding this code. Is my simulation realistic? If not, which parts contain errors? I would also welcome any recommended validation or sanity checks.

I have attached the MATLAB codes (Code1.m and Code2.m) below for reference.

Thank you! 3d volume, 6d movements, applyrigidtransform3d MATLAB Answers — New Questions

​