I would like to ask for your guidance regarding my use of the UCIe 2.0 Standard Package Signal Integrity Kit.
In the documentation, a script (run_plotVTF.m) for calculating the VTF is mentioned, as illustrated in the figure below. However, I was not able to locate this file after searching through the provided package.

I also have an additional question: is it possible to run the VTF calculation tool independently, without waiting for the coupled widebus simulation to be completed?
Based on my understanding, the VTF simulation itself is essentially a passive simulation.I would like to ask for your guidance regarding my use of the UCIe 2.0 Standard Package Signal Integrity Kit.
In the documentation, a script (run_plotVTF.m) for calculating the VTF is mentioned, as illustrated in the figure below. However, I was not able to locate this file after searching through the provided package.

I also have an additional question: is it possible to run the VTF calculation tool independently, without waiting for the coupled widebus simulation to be completed?
Based on my understanding, the VTF simulation itself is essentially a passive simulation. I would like to ask for your guidance regarding my use of the UCIe 2.0 Standard Package Signal Integrity Kit.
In the documentation, a script (run_plotVTF.m) for calculating the VTF is mentioned, as illustrated in the figure below. However, I was not able to locate this file after searching through the provided package.

I also have an additional question: is it possible to run the VTF calculation tool independently, without waiting for the coupled widebus simulation to be completed?
Based on my understanding, the VTF simulation itself is essentially a passive simulation. ucie 2.0, parallel link designer, vtf, script MATLAB Answers — New Questions

​