Hi,

I’m working through this example* for the Xilinx Zynq UltraScale+ RFSoC ZCU111 Evaluation Kit with MATLAB R2023b. I have Simulink, all of the required toolboxes and Vivado installed allowing me to simulate the design; build the HDL and firmware images; load the base image onto the SD card and onto the RFSoC. However, when I try to Monitor & Tune, running the example on the hardware, I get the following:

Furthermore, if i go into ‘System on Chip’ > ‘Hardware Implementation’ > ‘Target hardware resources’ > ‘External mode’, I cannot specify an IPv4 address or serial port for the XCP server as others have suggested in various other responses:

Serial-ing into the target, all of the files and network config appear correct, so I’m not sure what the issue is:

Any ideas what the issue could be and how to solve it?
Thanks

*Transmit Signal Waveform Using DDR4 on Xilinx RFSoC Device – MATLAB & Simulink – MathWorks United KingdomHi,

I’m working through this example* for the Xilinx Zynq UltraScale+ RFSoC ZCU111 Evaluation Kit with MATLAB R2023b. I have Simulink, all of the required toolboxes and Vivado installed allowing me to simulate the design; build the HDL and firmware images; load the base image onto the SD card and onto the RFSoC. However, when I try to Monitor & Tune, running the example on the hardware, I get the following:

Furthermore, if i go into ‘System on Chip’ > ‘Hardware Implementation’ > ‘Target hardware resources’ > ‘External mode’, I cannot specify an IPv4 address or serial port for the XCP server as others have suggested in various other responses:

Serial-ing into the target, all of the files and network config appear correct, so I’m not sure what the issue is:

Any ideas what the issue could be and how to solve it?
Thanks

*Transmit Signal Waveform Using DDR4 on Xilinx RFSoC Device – MATLAB & Simulink – MathWorks United Kingdom Hi,

I’m working through this example* for the Xilinx Zynq UltraScale+ RFSoC ZCU111 Evaluation Kit with MATLAB R2023b. I have Simulink, all of the required toolboxes and Vivado installed allowing me to simulate the design; build the HDL and firmware images; load the base image onto the SD card and onto the RFSoC. However, when I try to Monitor & Tune, running the example on the hardware, I get the following:

Furthermore, if i go into ‘System on Chip’ > ‘Hardware Implementation’ > ‘Target hardware resources’ > ‘External mode’, I cannot specify an IPv4 address or serial port for the XCP server as others have suggested in various other responses:

Serial-ing into the target, all of the files and network config appear correct, so I’m not sure what the issue is:

Any ideas what the issue could be and how to solve it?
Thanks

*Transmit Signal Waveform Using DDR4 on Xilinx RFSoC Device – MATLAB & Simulink – MathWorks United Kingdom zcu111, rfsoc, simulink, xcp MATLAB Answers — New Questions

​