I have a control loop such that:
The loop starts by calculating the error between the desired and measured temperature.
The relay block turns the heating system on or off based on this error, with a hysteresis of ±5 degrees to prevent frequent switching.
The output from the relay (on/off signal) is passed through a transfer function to simulate the dynamics of the system (introducing a delay or lag in the heating response).
The scaled output from the transfer function (now a power signal) is converted into a physical signal.
Finally, the physical signal controls the heat source, which in turn affects the system’s temperature.
I want to use PID controller block instead of this, how can I achieve that?I have a control loop such that:
The loop starts by calculating the error between the desired and measured temperature.
The relay block turns the heating system on or off based on this error, with a hysteresis of ±5 degrees to prevent frequent switching.
The output from the relay (on/off signal) is passed through a transfer function to simulate the dynamics of the system (introducing a delay or lag in the heating response).
The scaled output from the transfer function (now a power signal) is converted into a physical signal.
Finally, the physical signal controls the heat source, which in turn affects the system’s temperature.
I want to use PID controller block instead of this, how can I achieve that? I have a control loop such that:
The loop starts by calculating the error between the desired and measured temperature.
The relay block turns the heating system on or off based on this error, with a hysteresis of ±5 degrees to prevent frequent switching.
The output from the relay (on/off signal) is passed through a transfer function to simulate the dynamics of the system (introducing a delay or lag in the heating response).
The scaled output from the transfer function (now a power signal) is converted into a physical signal.
Finally, the physical signal controls the heat source, which in turn affects the system’s temperature.
I want to use PID controller block instead of this, how can I achieve that? simulink, pid, simscape MATLAB Answers — New Questions

​