I get the following error –
An error occurred while running the simulation and the simulation was terminated
Caused by:
Derivative of state ‘1’ in block ‘gam_control1/PID Controller2/Integrator/Continuous/Integrator’ at time 301.02267725611046 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)
I am using a manually created signal (using signal editor) as an input into a PID controller. I have tried to select ODE15 from the model configurations and also tried tightening the absolute error. Nothing works. The simulation stops at 300 s. I need it to run till 550 s. Please help.I get the following error –
An error occurred while running the simulation and the simulation was terminated
Caused by:
Derivative of state ‘1’ in block ‘gam_control1/PID Controller2/Integrator/Continuous/Integrator’ at time 301.02267725611046 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)
I am using a manually created signal (using signal editor) as an input into a PID controller. I have tried to select ODE15 from the model configurations and also tried tightening the absolute error. Nothing works. The simulation stops at 300 s. I need it to run till 550 s. Please help. I get the following error –
An error occurred while running the simulation and the simulation was terminated
Caused by:
Derivative of state ‘1’ in block ‘gam_control1/PID Controller2/Integrator/Continuous/Integrator’ at time 301.02267725611046 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)
I am using a manually created signal (using signal editor) as an input into a PID controller. I have tried to select ODE15 from the model configurations and also tried tightening the absolute error. Nothing works. The simulation stops at 300 s. I need it to run till 550 s. Please help. simulink, error MATLAB Answers — New Questions

​