After each restart, the parameters of the multimeter blocks change randomly (Simulink Simscape Electrical – Specialized Power Systems)
Hey everyone,
I am currently using Simulink Simscape Electrical Specialized Power Systems extensively for my work. However, I have encountered a persistent issue that I find quite bothersome.
In order to perform measurements of voltages, currents, etc., I rely on several multimeter blocks. Unfortunately, after each program restart, the output parameters/measurement parameters of these multimeter blocks change randomly. As a result, I have to reconfigure the multimeter blocks every time I restart the program. This process is quite cumbersome and time-consuming.
I was wondering if any of you have experienced the same or a similar issue and could provide me with some guidance or assistance in resolving it.
Thank you in advance for your help.
Best regards,
TorbenHey everyone,
I am currently using Simulink Simscape Electrical Specialized Power Systems extensively for my work. However, I have encountered a persistent issue that I find quite bothersome.
In order to perform measurements of voltages, currents, etc., I rely on several multimeter blocks. Unfortunately, after each program restart, the output parameters/measurement parameters of these multimeter blocks change randomly. As a result, I have to reconfigure the multimeter blocks every time I restart the program. This process is quite cumbersome and time-consuming.
I was wondering if any of you have experienced the same or a similar issue and could provide me with some guidance or assistance in resolving it.
Thank you in advance for your help.
Best regards,
Torben Hey everyone,
I am currently using Simulink Simscape Electrical Specialized Power Systems extensively for my work. However, I have encountered a persistent issue that I find quite bothersome.
In order to perform measurements of voltages, currents, etc., I rely on several multimeter blocks. Unfortunately, after each program restart, the output parameters/measurement parameters of these multimeter blocks change randomly. As a result, I have to reconfigure the multimeter blocks every time I restart the program. This process is quite cumbersome and time-consuming.
I was wondering if any of you have experienced the same or a similar issue and could provide me with some guidance or assistance in resolving it.
Thank you in advance for your help.
Best regards,
Torben multimeter, simulink simscape electrical, specialized power systems MATLAB Answers — New Questions