A few days ago someone pointed out that using:
clc; clear; close all;
Is considered as a case of code smell and cargo cult programming.
But does that really have to be the case?
clc: cleans up the command window and now one can work without getting confused with the commands for previous runs
clear: erases the variables from previous runs this will reduce chances of error in subsequent runs and the programmer does not have to worry about unnecessary trash variables.
close all: closes all currently open figures. This can be very helpful during subsequent runs of the same script. If the figure from the previous run has not been closed then the subsequent run will plot the data on the already open figure. Which of course is a total waste.

What is the problem with using these commands?A few days ago someone pointed out that using:
clc; clear; close all;
Is considered as a case of code smell and cargo cult programming.
But does that really have to be the case?
clc: cleans up the command window and now one can work without getting confused with the commands for previous runs
clear: erases the variables from previous runs this will reduce chances of error in subsequent runs and the programmer does not have to worry about unnecessary trash variables.
close all: closes all currently open figures. This can be very helpful during subsequent runs of the same script. If the figure from the previous run has not been closed then the subsequent run will plot the data on the already open figure. Which of course is a total waste.

What is the problem with using these commands? A few days ago someone pointed out that using:
clc; clear; close all;
Is considered as a case of code smell and cargo cult programming.
But does that really have to be the case?
clc: cleans up the command window and now one can work without getting confused with the commands for previous runs
clear: erases the variables from previous runs this will reduce chances of error in subsequent runs and the programmer does not have to worry about unnecessary trash variables.
close all: closes all currently open figures. This can be very helpful during subsequent runs of the same script. If the figure from the previous run has not been closed then the subsequent run will plot the data on the already open figure. Which of course is a total waste.

What is the problem with using these commands? codesmell, cargocultprogramming, clc, clear, close all MATLAB Answers — New Questions

​