I’m doing optimization using fmincon.

I used ObjectiveLimit to terminate the optimization when the size of the objective function is less than 0.2,
As I was writing the code, it seems that if the nonlinear constraints are satisfied, the termination condition is also satisfied.
However, when I run the code, the optimization is performed several times and then the code terminates.
I don’t understand this part.
Doesn’t fmincon perform optimization for cases that satisfy the constraints?

What happens if the termination condition is satisfied before the constraint in matlab’s fmincon?

Below is the output when optimization is finished.
fmincon stopped because the objective function value 6.018404e-04 is less than options.ObjectiveLimit = 2.000000e-01 and the relative maximum constraint violation 2.039171e-13 is less than options.ConstraintTolerance = 1.000000e-06

Thank you.I’m doing optimization using fmincon.

I used ObjectiveLimit to terminate the optimization when the size of the objective function is less than 0.2,
As I was writing the code, it seems that if the nonlinear constraints are satisfied, the termination condition is also satisfied.
However, when I run the code, the optimization is performed several times and then the code terminates.
I don’t understand this part.
Doesn’t fmincon perform optimization for cases that satisfy the constraints?

What happens if the termination condition is satisfied before the constraint in matlab’s fmincon?

Below is the output when optimization is finished.
fmincon stopped because the objective function value 6.018404e-04 is less than options.ObjectiveLimit = 2.000000e-01 and the relative maximum constraint violation 2.039171e-13 is less than options.ConstraintTolerance = 1.000000e-06

Thank you. I’m doing optimization using fmincon.

I used ObjectiveLimit to terminate the optimization when the size of the objective function is less than 0.2,
As I was writing the code, it seems that if the nonlinear constraints are satisfied, the termination condition is also satisfied.
However, when I run the code, the optimization is performed several times and then the code terminates.
I don’t understand this part.
Doesn’t fmincon perform optimization for cases that satisfy the constraints?

What happens if the termination condition is satisfied before the constraint in matlab’s fmincon?

Below is the output when optimization is finished.
fmincon stopped because the objective function value 6.018404e-04 is less than options.ObjectiveLimit = 2.000000e-01 and the relative maximum constraint violation 2.039171e-13 is less than options.ConstraintTolerance = 1.000000e-06

Thank you. matlab, code, fmincon, optimization, constraint MATLAB Answers — New Questions

​