I did a simulink simulation for PV array with DC/DC Buck Converter to charged the battery. But i after try to simulate it i found that my PV voltage is close to my Output Voltage. It seems like its not a correct results. The parameter of PV Voc (19V), Isc (0.124A) ,Vmp (15.4V), Imp ( 0.1A) is set by my ownself from a solar panel datasheet. While the converter should step down the voltage to 8.4V (2s lithium ion battery). P&O MPPT already been implement in this circuit.I did a simulink simulation for PV array with DC/DC Buck Converter to charged the battery. But i after try to simulate it i found that my PV voltage is close to my Output Voltage. It seems like its not a correct results. The parameter of PV Voc (19V), Isc (0.124A) ,Vmp (15.4V), Imp ( 0.1A) is set by my ownself from a solar panel datasheet. While the converter should step down the voltage to 8.4V (2s lithium ion battery). P&O MPPT already been implement in this circuit. I did a simulink simulation for PV array with DC/DC Buck Converter to charged the battery. But i after try to simulate it i found that my PV voltage is close to my Output Voltage. It seems like its not a correct results. The parameter of PV Voc (19V), Isc (0.124A) ,Vmp (15.4V), Imp ( 0.1A) is set by my ownself from a solar panel datasheet. While the converter should step down the voltage to 8.4V (2s lithium ion battery). P&O MPPT already been implement in this circuit. mppt, dc/dc converter, pv arrays, buck converter, maximum power point tracking, charging, battery MATLAB Answers — New Questions

​