CCCV Charging of Batteries does not works
Hi Community,
I have created a Panasonic Battery Pack NCR18650BD arrange in the following configuration 6S1P. However my model does not works and the battery does not charge up at all using CCCV? I just get a flat curve throughout. The current does not even goes to the charge current of 1.375A
Does anyone have any idea how to resolve this issue?
The settings are as follow:
Initial SOC
[0.3 0.3 0.3 0.3 0.3 0.3]
Relay Settings:
0.9 Turn On
0.3 Turn Off
CCCV Settings:
Maximum Cell Settings: 4.2
Controller Proportional Gain:100
Controller Integral Gain:10
Controller Anti Windup Gain:1
Gain of Signal Feedback Tracking Loop: 1
Sample Time: 1
Unit Delay:
Initial Condition: 0
Attached are the images and the code below.Hi Community,
I have created a Panasonic Battery Pack NCR18650BD arrange in the following configuration 6S1P. However my model does not works and the battery does not charge up at all using CCCV? I just get a flat curve throughout. The current does not even goes to the charge current of 1.375A
Does anyone have any idea how to resolve this issue?
The settings are as follow:
Initial SOC
[0.3 0.3 0.3 0.3 0.3 0.3]
Relay Settings:
0.9 Turn On
0.3 Turn Off
CCCV Settings:
Maximum Cell Settings: 4.2
Controller Proportional Gain:100
Controller Integral Gain:10
Controller Anti Windup Gain:1
Gain of Signal Feedback Tracking Loop: 1
Sample Time: 1
Unit Delay:
Initial Condition: 0
Attached are the images and the code below. Hi Community,
I have created a Panasonic Battery Pack NCR18650BD arrange in the following configuration 6S1P. However my model does not works and the battery does not charge up at all using CCCV? I just get a flat curve throughout. The current does not even goes to the charge current of 1.375A
Does anyone have any idea how to resolve this issue?
The settings are as follow:
Initial SOC
[0.3 0.3 0.3 0.3 0.3 0.3]
Relay Settings:
0.9 Turn On
0.3 Turn Off
CCCV Settings:
Maximum Cell Settings: 4.2
Controller Proportional Gain:100
Controller Integral Gain:10
Controller Anti Windup Gain:1
Gain of Signal Feedback Tracking Loop: 1
Sample Time: 1
Unit Delay:
Initial Condition: 0
Attached are the images and the code below. simscape, battery_system_management, cccv MATLAB Answers — New Questions