I am working on implementing the table from TS138.101 Table 6.2.2.1.1.1-1: CQI reporting definition test using MATLAB’s 5G toolbox example, "NR PDSCH Throughput Using Channel State Information Feedback". The table specifies that the number of CSI-RS ports (X) should be 2, with an antenna configuration of 2×2.
In the MATLAB example, setting the panel dimensions to 2×2 results in NTxAnt becoming 8, which corresponds to the number of CSI-RS ports. However, according to the test table, to set the number of CSI-RS ports (X) to 2, the row number should be set to 3. When attempting to do this, MATLAB returns an error stating that the row number must be 6 or above. How can I correctly configure the antenna to 2×2 while ensuring the number of CSI-RS ports is set to 2, as required by the test table?I am working on implementing the table from TS138.101 Table 6.2.2.1.1.1-1: CQI reporting definition test using MATLAB’s 5G toolbox example, "NR PDSCH Throughput Using Channel State Information Feedback". The table specifies that the number of CSI-RS ports (X) should be 2, with an antenna configuration of 2×2.
In the MATLAB example, setting the panel dimensions to 2×2 results in NTxAnt becoming 8, which corresponds to the number of CSI-RS ports. However, according to the test table, to set the number of CSI-RS ports (X) to 2, the row number should be set to 3. When attempting to do this, MATLAB returns an error stating that the row number must be 6 or above. How can I correctly configure the antenna to 2×2 while ensuring the number of CSI-RS ports is set to 2, as required by the test table? I am working on implementing the table from TS138.101 Table 6.2.2.1.1.1-1: CQI reporting definition test using MATLAB’s 5G toolbox example, "NR PDSCH Throughput Using Channel State Information Feedback". The table specifies that the number of CSI-RS ports (X) should be 2, with an antenna configuration of 2×2.
In the MATLAB example, setting the panel dimensions to 2×2 results in NTxAnt becoming 8, which corresponds to the number of CSI-RS ports. However, according to the test table, to set the number of CSI-RS ports (X) to 2, the row number should be set to 3. When attempting to do this, MATLAB returns an error stating that the row number must be 6 or above. How can I correctly configure the antenna to 2×2 while ensuring the number of CSI-RS ports is set to 2, as required by the test table? 5g, cqi MATLAB Answers — New Questions

​