Hello Matlab Support Team,
I am currently using Simulink to implement CAN communication with an STM32-NucleoF446RE board, but I am facing some difficulties and would like to request support.
At the moment, I have connected an MCU-230 transceiver to a 500 kbit/s CAN bus, with the RX-TX lines of the transceiver connected to the STM32 board. I have also ensured that the baud rate is set correctly, but the problem of not receiving any values through CAN Receive persists.
Attached are some images showing parts of the code I have written and screenshots from STM32 IDE.

If there is any information you need, feel free to ask, and I will provide it. Also, if I have made any mistakes, please don’t hesitate to contact me.Hello Matlab Support Team,
I am currently using Simulink to implement CAN communication with an STM32-NucleoF446RE board, but I am facing some difficulties and would like to request support.
At the moment, I have connected an MCU-230 transceiver to a 500 kbit/s CAN bus, with the RX-TX lines of the transceiver connected to the STM32 board. I have also ensured that the baud rate is set correctly, but the problem of not receiving any values through CAN Receive persists.
Attached are some images showing parts of the code I have written and screenshots from STM32 IDE.

If there is any information you need, feel free to ask, and I will provide it. Also, if I have made any mistakes, please don’t hesitate to contact me. Hello Matlab Support Team,
I am currently using Simulink to implement CAN communication with an STM32-NucleoF446RE board, but I am facing some difficulties and would like to request support.
At the moment, I have connected an MCU-230 transceiver to a 500 kbit/s CAN bus, with the RX-TX lines of the transceiver connected to the STM32 board. I have also ensured that the baud rate is set correctly, but the problem of not receiving any values through CAN Receive persists.
Attached are some images showing parts of the code I have written and screenshots from STM32 IDE.

If there is any information you need, feel free to ask, and I will provide it. Also, if I have made any mistakes, please don’t hesitate to contact me. can, stm32f4xx, embedded coder, simulink MATLAB Answers — New Questions

​