I’m using ESP32 WROOM DevKitC and simply trying to ‘Monitor and tune’ a simple servo control simulink block but getting the error ‘Failed to run the model on hardware.’
The following error was encountered during evaluation of the external mode callback ‘getExtModeData’: codertarget.arduinobase.internal.getExternalModeMexArgs(‘Serial’) No ESP32-WROOM-DevKitV1(30 pin) board detected. Install or update the Arduino board driver and try again. If the problem persists, enter the host COM port number manually in the Host-board connection parameter and try again.The following error was encountered during evaluation of the external mode callback ‘getExtModeData’: codertarget.arduinobase.internal.getExternalModeMexArgs(‘Serial’) No ESP32-WROOM-DevKitV1(30 pin) board detected. Install or update the Arduino board driver and try again. If the problem persists, enter the host COM port number manually in the Host-board connection parameter and try again. The following error was encountered during evaluation of the external mode callback ‘getExtModeData’: codertarget.arduinobase.internal.getExternalModeMexArgs(‘Serial’) No ESP32-WROOM-DevKitV1(30 pin) board detected. Install or update the Arduino board driver and try again. If the problem persists, enter the host COM port number manually in the Host-board connection parameter and try again. simulink, esp32, servo MATLAB Answers — New Questions
