On NixOS (glnxa64), when I have Flatpak enabled, I will receive an error from the following:
Install Simulink Support Package for Arduino Hardware add-on
Start Hardware Setup wizard in said add-on
Get to the stage where the wizard prompts me to Connect an Arduino Board and is detecting boards
Receive error "JSON syntax error at line 1 (character 1), expected ‘false’ but found ‘flatpak’"
There seem to be no log created for this error (or for the Hardware Setup wizard in general), so it’s been difficult for me to debug the exact reason that this is occuring.

The only way I’ve found to work around this error is to remove Flatpak from my system during Hardware Setup, and re-enable it later. Though there is no guarantee that Arduino support in Simulink will continue to work after I’ve re-enabled Flatpak (I’ve not tested), so I thought it’s important nevertheless for me to raise this issue.On NixOS (glnxa64), when I have Flatpak enabled, I will receive an error from the following:
Install Simulink Support Package for Arduino Hardware add-on
Start Hardware Setup wizard in said add-on
Get to the stage where the wizard prompts me to Connect an Arduino Board and is detecting boards
Receive error "JSON syntax error at line 1 (character 1), expected ‘false’ but found ‘flatpak’"
There seem to be no log created for this error (or for the Hardware Setup wizard in general), so it’s been difficult for me to debug the exact reason that this is occuring.

The only way I’ve found to work around this error is to remove Flatpak from my system during Hardware Setup, and re-enable it later. Though there is no guarantee that Arduino support in Simulink will continue to work after I’ve re-enabled Flatpak (I’ve not tested), so I thought it’s important nevertheless for me to raise this issue. On NixOS (glnxa64), when I have Flatpak enabled, I will receive an error from the following:
Install Simulink Support Package for Arduino Hardware add-on
Start Hardware Setup wizard in said add-on
Get to the stage where the wizard prompts me to Connect an Arduino Board and is detecting boards
Receive error "JSON syntax error at line 1 (character 1), expected ‘false’ but found ‘flatpak’"
There seem to be no log created for this error (or for the Hardware Setup wizard in general), so it’s been difficult for me to debug the exact reason that this is occuring.

The only way I’ve found to work around this error is to remove Flatpak from my system during Hardware Setup, and re-enable it later. Though there is no guarantee that Arduino support in Simulink will continue to work after I’ve re-enabled Flatpak (I’ve not tested), so I thought it’s important nevertheless for me to raise this issue. arduino, simulink, support package, hardware setup MATLAB Answers — New Questions

​