I’m currently using matalb2024a and using pixhak6c.

I want to control without using Radio Control, so I planned to use telemetry radio.

When monitor and tune simulation is started using USB (COM11), it works normally, but it does not connect when telemetry (/dev/ty/S5, COM3) is used.

Error: External Mode Open Protocol Connect command fails
Cause:
Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command

In the Qgroundcontrol parameter setting, MAV_CONFIG_0 was set to disabled.

Is there a solution?I’m currently using matalb2024a and using pixhak6c.

I want to control without using Radio Control, so I planned to use telemetry radio.

When monitor and tune simulation is started using USB (COM11), it works normally, but it does not connect when telemetry (/dev/ty/S5, COM3) is used.

Error: External Mode Open Protocol Connect command fails
Cause:
Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command

In the Qgroundcontrol parameter setting, MAV_CONFIG_0 was set to disabled.

Is there a solution? I’m currently using matalb2024a and using pixhak6c.

I want to control without using Radio Control, so I planned to use telemetry radio.

When monitor and tune simulation is started using USB (COM11), it works normally, but it does not connect when telemetry (/dev/ty/S5, COM3) is used.

Error: External Mode Open Protocol Connect command fails
Cause:
Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command

In the Qgroundcontrol parameter setting, MAV_CONFIG_0 was set to disabled.

Is there a solution? pixhawk6c, sik telemetry, monitor and tune MATLAB Answers — New Questions

​