Hi,
I am getting an error while trying to simulate a Single phase Asynchronous motor. When I change the pole pair from 2 which is the default to 1 I am getting negative rpm. When the pole pair is 2 or 3 or 4 it works fine with the correct speed and positive rpm.

This is the block of AC Cap-Start/Run motor:

Best regards,
Andrew.Hi,
I am getting an error while trying to simulate a Single phase Asynchronous motor. When I change the pole pair from 2 which is the default to 1 I am getting negative rpm. When the pole pair is 2 or 3 or 4 it works fine with the correct speed and positive rpm.

This is the block of AC Cap-Start/Run motor:

Best regards,
Andrew. Hi,
I am getting an error while trying to simulate a Single phase Asynchronous motor. When I change the pole pair from 2 which is the default to 1 I am getting negative rpm. When the pole pair is 2 or 3 or 4 it works fine with the correct speed and positive rpm.

This is the block of AC Cap-Start/Run motor:

Best regards,
Andrew. single phase asynchronous motor, cap-start MATLAB Answers — New Questions

​