Hi All,
Forgive me if this topic of signal resetting in Simscape has been ask and solved countless times before. However, I am struggling to what seems a basic bit of logic in my Simscape model, and the solutons in the MATHWORKS examples I can find, seem to not reset the angular position signal by way of my trigger signal (I also have a rising edge signal).
Simply need to reset the angular position output from the Ideal Rotational Motion Sensor (converted to degrees) when my piston reaches its TDC position.
Using triggered subsystems to pass the signal through, or an integrator with a reset and manual swiches, are not permit the signal value to increase at each time-step once reset to 0.
Any pointer would be great on what should be a 5 minute task.
Thanks again.

Patrick

TDC Switch

Rising Edge SignalHi All,
Forgive me if this topic of signal resetting in Simscape has been ask and solved countless times before. However, I am struggling to what seems a basic bit of logic in my Simscape model, and the solutons in the MATHWORKS examples I can find, seem to not reset the angular position signal by way of my trigger signal (I also have a rising edge signal).
Simply need to reset the angular position output from the Ideal Rotational Motion Sensor (converted to degrees) when my piston reaches its TDC position.
Using triggered subsystems to pass the signal through, or an integrator with a reset and manual swiches, are not permit the signal value to increase at each time-step once reset to 0.
Any pointer would be great on what should be a 5 minute task.
Thanks again.

Patrick

TDC Switch

Rising Edge Signal Hi All,
Forgive me if this topic of signal resetting in Simscape has been ask and solved countless times before. However, I am struggling to what seems a basic bit of logic in my Simscape model, and the solutons in the MATHWORKS examples I can find, seem to not reset the angular position signal by way of my trigger signal (I also have a rising edge signal).
Simply need to reset the angular position output from the Ideal Rotational Motion Sensor (converted to degrees) when my piston reaches its TDC position.
Using triggered subsystems to pass the signal through, or an integrator with a reset and manual swiches, are not permit the signal value to increase at each time-step once reset to 0.
Any pointer would be great on what should be a 5 minute task.
Thanks again.

Patrick

TDC Switch

Rising Edge Signal simulink, simscape, stateflow MATLAB Answers — New Questions

​