I am trying to compile a simple gpio trigger signal that I created with Simulink and run it on the raspberry. But unfortunately, when I measure with an oscilloscope from the gpio pin, which should trigger 2khz, I see a 2hz measurement. I would appreciate if you can help with this. It is interesting that even *very simple models* have such problems. (Matlab2024a)I am trying to compile a simple gpio trigger signal that I created with Simulink and run it on the raspberry. But unfortunately, when I measure with an oscilloscope from the gpio pin, which should trigger 2khz, I see a 2hz measurement. I would appreciate if you can help with this. It is interesting that even *very simple models* have such problems. (Matlab2024a) I am trying to compile a simple gpio trigger signal that I created with Simulink and run it on the raspberry. But unfortunately, when I measure with an oscilloscope from the gpio pin, which should trigger 2khz, I see a 2hz measurement. I would appreciate if you can help with this. It is interesting that even *very simple models* have such problems. (Matlab2024a) simulink, code generation MATLAB Answers — New Questions

​