Hi.
I need some help in predefining a test procedure for a remote Oven with ON/OFF Control. A step response is unsuitable because the oven is overpowered. Will a simple ON till the temperature reaches a typical working temperature followed by on OFF be sufficient? Can the collected data then be used for analysis to determine controller constants?
If that ON/OFF test is inadequate, will multiple ON/OFF’s be better as this would fall into the category of variable input?
Thanks.Hi.
I need some help in predefining a test procedure for a remote Oven with ON/OFF Control. A step response is unsuitable because the oven is overpowered. Will a simple ON till the temperature reaches a typical working temperature followed by on OFF be sufficient? Can the collected data then be used for analysis to determine controller constants?
If that ON/OFF test is inadequate, will multiple ON/OFF’s be better as this would fall into the category of variable input?
Thanks. Hi.
I need some help in predefining a test procedure for a remote Oven with ON/OFF Control. A step response is unsuitable because the oven is overpowered. Will a simple ON till the temperature reaches a typical working temperature followed by on OFF be sufficient? Can the collected data then be used for analysis to determine controller constants?
If that ON/OFF test is inadequate, will multiple ON/OFF’s be better as this would fall into the category of variable input?
Thanks. pid, pid constants, on/off control MATLAB Answers — New Questions

​