Why is there no “if” condition for a “switch” block in generated code?
I am using MATLAB R2024a with Embedded Coder. In my Simulink model, I have a "Switch" that chooses between two signals. I found the code for the "Switch" block in the generated code. However, it does not contain an "if" statement, and it always sets the output signal to the same value:
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
*/
outSignal = myInput1;
I want the code to switch between the two signals I send into the "Switch" block like so:
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
* RelationalOperator: ‘<S1>/Compare’
*/
if (controlSignal) < 0)
{
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
*/
outSignal = myInput1;
}
else
{
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In2’
*/
outSignal = myInput2;
}
Why is the code missing the "if" condition? Is this a bug?I am using MATLAB R2024a with Embedded Coder. In my Simulink model, I have a "Switch" that chooses between two signals. I found the code for the "Switch" block in the generated code. However, it does not contain an "if" statement, and it always sets the output signal to the same value:
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
*/
outSignal = myInput1;
I want the code to switch between the two signals I send into the "Switch" block like so:
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
* RelationalOperator: ‘<S1>/Compare’
*/
if (controlSignal) < 0)
{
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
*/
outSignal = myInput1;
}
else
{
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In2’
*/
outSignal = myInput2;
}
Why is the code missing the "if" condition? Is this a bug? I am using MATLAB R2024a with Embedded Coder. In my Simulink model, I have a "Switch" that chooses between two signals. I found the code for the "Switch" block in the generated code. However, it does not contain an "if" statement, and it always sets the output signal to the same value:
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
*/
outSignal = myInput1;
I want the code to switch between the two signals I send into the "Switch" block like so:
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
* RelationalOperator: ‘<S1>/Compare’
*/
if (controlSignal) < 0)
{
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In1’
*/
outSignal = myInput1;
}
else
{
/* Switch: ‘<Root>/Switch’ incorporates:
* Inport: ‘<Root>/In2’
*/
outSignal = myInput2;
}
Why is the code missing the "if" condition? Is this a bug? switch, if, if-else, switch-block, eliminated, virtual, optimization, optimize, generatetracereport MATLAB Answers — New Questions
